Operation Manual

PIX-75 www.amano.com/time  1-800-253-9836 18
Note – Pressing the PROGRAM button while performing custom
print line setup with symbol printing will end the custom print
submenu without altering the program.
TCX-85 Symbol Printing
If the print format is not acceptable to the user, the user can create a
maximum of 2 print lines for their desired print format.
If only line 1 is programmed, the user can print the line automatically (paper
sensor) or manually (either one of two top print buttons) based on the “print
method” selected. If line 1 and line 2 are both programmed, the user can
print the lines via these options:
 If the “print method” is set to “Auto”, the clock will print line 1 the first
time paper is inserted, and print line 2 the second time the paper is
inserted. Repeat this pattern for subsequent printing.
Note – After line 1 is printed, the user has to insert the paper
before the 5 second timeout for line 2 occurs in order to print line
2. Otherwise, the clock will print Line 1 after the Line 2 timeout.
 If the “print method” is set to “Manual”, the clock will print line 1 when
user presses the top left button [labeled minus], and print line 2 when
user presses the top right button [labeled plus] (see Figure 8 & Figure 9
on page 46) without using the paper sensor.
All available symbols are listed in the following table with the length
expressed in dots and percent of maximum line length allowed (160 dots).