Operation Manual
PIX-75 www.amano.com/time 1-800-253-9836 17
5. Press the + or – button to navigate to the desired symbol to be added
[by default “2D YEAR” symbol will always be the first symbol shown for
insertion]. Then press the ENTER button once to accept the flashing
symbol value. (Display will now show “NONE”)
6. Press the + or – button to navigate to the next symbol in the print line.
[Hint: This symbol should be the symbol you want to print AFTER the
added symbol. (Example: If symbol of “MONTH” was added before the
symbol “DATE”. In this step, use + or – to Choose symbol DATE to
replace NONE). Then press ENTER.
7. Keep pressing the ENTER button until you see the flashing “END”
symbol. Press ENTER again to save and complete the line 1 or line 2 of
symbol printing.
Failure to finish a line 1 or line 2 of symbol printing without entering the
“END” symbol will cause the entire line not to be saved.
Note – Pressing the PROGRAM button while performing custom
print line setup with symbol printing will end the custom print
submenu without altering the program.
To Delete a Symbol from a Custom Print Line
1. Press the ENTER button once from the P506
submenu and the clock will display Line – 1
and the number of programmed symbols (see
right-hand Figure for example of a line-1 with 5
symbols).
2. If desired, press the + button once to advance to
Line – 2.
3. Press the ENTER button once to enter into the custom print line. The
first symbol chosen will be flashing. Press ENTER on each symbol to
navigate through the print line of symbols to the symbol you want to
delete [the symbol that will be deleted will be the flashing symbol]. With
the symbol to be deleted flashing use the + or – buttons to navigate to
the “DEL” symbol.
4. Press the ENTER button once to perform the deletion.
5. Keep pressing the ENTER button until you see the “END” symbol.
Press the ENTER button again to finish the deletion process and save
the modified line 1 or line 2.
Failure to finish a line 1 or line 2 of symbol printing without entering the
“END” symbol will cause the entire line not to be saved.