Operation Manual

PIX-75 www.amano.com/time  1-800-253-9836 16
10. If desired, press the + button once to advance to
Line – 2 custom programming (see right-hand
Figure).
11. Press the ENTER button to begin symbol
programming for line 2 and follow the same
procedure as described in steps 8 and 9. The first
symbol to appear will be the “END” symbol (see
right-hand Figure).
12. When finished, press the PROGRAM button 2
times to exit ALL programming or Press + to go
scroll through sub menu options for P5 Customize
again
To delete a Whole Line of Symbol Printing
1. Press the ENTER button once from the P506
submenu for custom print and the clock will display
Line – 1 and the number of programmed
symbols (see right-hand Figure for example of line-1
with 5 symbols).
2. If you need to delete/add a symbol in line 2 of
printing, press the + button once now to advance to Line – 2 then
follow steps below. Otherwise proceed with step 3 below.
3. Press the ENTER button once to enter into the custom print line. Press
the + or – buttons to navigate to the “END” symbol. With this symbol
flashing on the Auxiliary Display Line, press the ENTER button once to
save the “END” symbol at the beginning of the symbol line. This will
terminate/delete that line of symbol printing.
To Add a Symbol to a Custom Print Line
1. Press the ENTER button once from the P506
submenu and the clock will display Line – 1 and
the number of programmed symbols (see right-
hand Figure for example of a line-1 with 5
symbols).
2. If desired, press the + button once to advance to
Line – 2.
3. Press the ENTER button once to enter into the custom print line. Press
the ENTER button on each symbol of your print line until you see the
symbol you want to insert something before. [The new symbol will
always be inserted before the flashing symbol].
4. Press the + or – button to navigate to the “ADD” symbol then press
ENTER to begin the add function.