Operation Manual

Amano TCX-22 Operation Manual 13
Setting the Leading Zero On or Off
Note: The Leading Zero appears on the print out before single digit times and
dates (For example DEC. 06, 08:00)
1. When the display flashes I5 2ErO, press the ENTER
button.
2. When the display flashes OFF or on, press the
CHANGE button to toggle between off and on. Press
the ENTER button to select.
3. When the display flashes I5 2ErO, press the CHANGE
button to move to the Begin Daylight Saving Time
setting.
Setting Begin Daylight Saving Time
Note: The government standard for DST is subject to change. Your clock is
factory-set for correct DST based upon when it was manufactured, but any
revision to DST begin or end dates may require updating the system-set
DST calendar.
The steps below change the begin date for DST. DST is enabled and
disabled in the Main Programming Menu. Updating the begin date for DST
needs to be done just one time*, since the clock's rolling calendar function
will auto-calculate the begin date for each year thereafter. To change the
end date for DST, refer to the next section.
1. When the display flashes I6 bdL , press the ENTER
button.
2. Press the CHANGE button until the correct year
appears, then press the ENTER button.
3. Press the CHANGE button until the correct month
appears, then press the ENTER button.
4. Press the CHANGE button until the correct date
appears, then press the ENTER button.
5. When the display flashes the correct year, month and
date, press the ENTER button.
6. When the display flashes I6 bdL
, press the CHANGE
button to move to the End Daylight Saving Time
Setting (17 EdL
will display).