Operation Manual

Amano TCX-21 Operation Manual 4
Make a Test Print
1. Make sure that there is power to the TCX-21 (Refer to Page 3).
2. Insert a piece of paper, or time card into the TCX-21. The clock will
automatically print YEAR, MONTH, DATE and TIME with AM or PM.
3. If the imprint is satisfactory, the TCX-21 is ready for use.
4. If you wish to change the time and/or print style on the TCX-21, enter
the Program Mode to make changes to the print styles. The next
page gives instructions on programming the TCX-21 to fit your
needs.
Adjusting the Margin
1. Unlock and remove the
cover. Note – suggest
unplugging the clock
before performing
margin adjustment.
2. Locate the Card Stopper
Adjustment Screw on the
right side of the clock,
below the printer platen.
3. Position a piece of paper or
time card as desired.
4. Loosen the screw to move
the Card Stopper forward or
back. Tighten the screw as
needed. (See top
illustration.) The print
margin can be adjusted to a
maximum of 7/8” (22 mm).