Operation Manual

Amano TCX-21 Operation Manual 3

Power Connection

Before connecting power, verify that the AC outlet voltage falls in the

range of 100-240 Volts AC and that the power cord and plug are

appropriate for your AC source. Plug the power cord into a properly

grounded 120 or 240 Volt wall outlet.

Wall Mounting

Note: Mounting screw locations should be marked on the wall. Do not insert a

drill bit through the mounting holes of the back plate when drilling holes.

1. Disconnect the power cord from the power source.

2. Unlock and remove the cover.

3. Locate the teardrop mounting hole and the two ¼" mounting holes in

the back plate.

4. Approximate the final location of the clock. Insert one #10 wood screw

or equivalent into the wall 1-1/2" (38 mm) from the top center location

of the clock.

Hang the clock on the screw using the teardrop mounting hole.

Secure the clock to the wall by inserting screws through the bottom

two mounting holes.

7. Reconnect the power cord to the power source.

8. Re-install the cover and secure.