Operation Manual

Amano PIX-200 Operation Manual 4-5
6. Press the (E) button again to return to the
“SEt UP Pro9” display.
PIX-200 Atomic Clock/Time Code Signal
Following is the amount of time for the PIX-200 to receive time code signals:
• When the radio wave condition is good, the clock will require
approximately 3 minutes to complete sysnchronization.
• During the automatic reception every night (from 1:15 am to 4:00 am),
it may take up to 166 minutes to complete time synchronization
depending on the radio wave reception.
• When you manually start reception, the clock will continue to search
for time code signals until this operation is discontinued. Refer to page
4-1 through 4-4 for more information about manual atomic clock
activation.