Operation Manual

4-4
Amano PIX-200 Operation Manual
Setting the Time Zone (US only)
This setup is for US only. In this setup, you can set
the time zone or select to disable the Atomic Clock
function.
1. Unlock and remove the cover.
2. Press (+) and (E) button on top of the unit at the
same time, holding down for 2 seconds until “SEt
UP Pro9” appears on the display.
3. Press the (+) button eleven times to position
the “” alongside the 5
th
line down from the
upper righthand corner in the display alongside
“OTHERS” (on the label).
2. Press (E) button and you will see
P1 LCd diSPly” display. Press (+) button
3 times to advance to “P4 CloC 5ync” display.
3. Press (E) button to set the time zone. When you
set the time zone, you need to input the
time difference from UTC (Universal Time
Coordinated). Please refer to the following chart.
For example, using the chart above, t 2onE
with – 5:00 should appear on the display for
Eastern Time Zone (EST).
4. When you see the “t 2onE” display where the
hour is blinking, select the time difference by
pressing (-) or (+) button. Press (E)
button to confirm the setting, and go to the
P5 End” display.
5. If you need to disable the Atomic Clock
function because of a failure to receive the
radio signal, interference, an inappropriate
location, or just bad radio wave receiving
conditions, please press (-) or (+) button
until you see “CLC SynC oFF”. Press the (E)
button to confirm the setting, and go to the
P5 End” display.
Note: if the unit can’t receive radio signals, try moving
the unit to another place where it can receive radio signals.
Time Difference from UTC Time Zone Major Cities
-5 EST New York, Boston
-6 CST Chicago, Houston
-7 MST Phoenix, Denver
-8 PST Los Angeles, San Francisco




SEt UP
ro
P188 LCd
di 5P Ly
MON TUE WED THU FRI SAT SUN
P488 CLoC
yn
MON TUE WED THU FRI SAT SUN
onE
0:00 88
MON TUE WED THU FRI SAT SUN
onE
-5:00 88
MON TUE WED THU FRI SAT SUN
MON TUE WED THU FRI SAT SUN
CLC 5ynC
FF 88
Blinking
MON TUE WED THU FRI SAT SUN