Operation Manual

3-20
Amano PIX-200 Operation Manual
If the PIX-200 requires a password
• When you press the (+) and (E) button at the same time for 2 seconds to
enter the “set up program” display.
• When you press the (+1 HOUR) or (+1 MIN.) button to change the time.
In case you forget the password
You can enter the “set up program” display by entering “1441”. Make sure you
only use the (-) button when you input this password or this password will not
work.
Note: Once a password has been entered, whenever you attempt to press the
(+) and (E) buttons on the top of the unit at the same time, and hold
down for 2 seconds you will see PASS “_ _ _ _” with the left “_” blinking
to begin entering the 4 digit password. Once the correct password has
been entered, SEt UP Pro9 will appear on the display and you can
perform changes to setup.