Operation Manual

3-14
Amano PIX-200 Operation Manual
Setting the Number
The illustrations to the right show samples of the displays. The shaded area
means that the symbols, numbers or characters are blinking.
In this setup, you can select the starting number for sequential number printing
and the number of digits for the printed number. Please make sure that you
have selected the imprint format, which includes number (Refer to page 3-4,
“Print Style Format”) or you have included “number” (Code No.19) when you
have programmed the customized comment. Please refer to page 6-1,
“Diagram of Character Code” for character code information.
To set the printed number perform the following:
1. Unlock and remove the cover.
2. Press the (+) and (E) buttons on the top
of the unit at the same time, holding down
for 2 seconds until SEt UP Pro9 appears
on the display. The “” on the top of the
display will be blinking.
3. Press the (+) button seven times to
position the “” alongside the 1
st
line in
the upper righthand corner of the display,
alongside “NUMBER” (on the label).
4. Press (E) button once to display
P1 Print nubEr” to set the starting
number (1
st
digit thru 8
th
digit depending
upon how many digits are selected
in the following step 5). Press the (E)
button once again, and the number to
be changed will be blinking. Select the
number (blinking digit) by pressing (-) or
(+) button (the choices for each digit are
0 – 9).
To move to the 2
nd
digit, press
the (E) button once again and the next
number to be changed will be blinking.
Continue pressing the (E) to advance one
digit to the right each time. Keep
advancing to the right and define all
digits shown on the display by following the
above procedure. After the last digit
displayed has been defined, press the (E)
button to confirm your setting and display
P2 nubEr di9it.
△△△△△△△
SEt UP
ro
MON TUE WED THU FRI SAT SUN
Blinking
△△
No.888888
1 0000000
MON TUE WED THU FRI SAT SUN
P2 ubEr
i9 it
MON TUE WED THU FRI SAT SUN
P1 rint
ub Er
MON TUE WED THU FRI SAT SUN