Operation Manual

Amano PIX-200 Operation Manual 3-7
How to delete the customized comment
When the print line number is blinking, (i.e., Prn LinE 1) press (+1 HOUR)
button for 3 seconds. The blinking will stop and the line number will light
steadily. Once the printing length returns to 0 and the line number starts
blinking again, the line you have selected and all the subsequent lines will be
deleted.
Setting the Layout for Customized Comments
The illustrations to the right show samples of the displays. The shaded area
means that the symbols, numbers or characters are blinking.
To set a layout for customized comments perform the following:
1. Unlock and remove the cover.
2. Press the (+) and (E) buttons on the top
of the unit at the same time, holding down
for 2 seconds until SEt UP Pro9 appears
on the display. The “▲” on the top of the
display will be blinking.
3. Press the (+) button twice to position the
“▲” under the WED.
4. Press the (E) button once to display the
print order (style) format and the code
number will be blinking. While the code
number is blinking, adjust code number to
32 (print style) by using the (-) or (+)
buttons.
5. Press the (E) button once to confirm the 32
and display P1 inPut CodE.
6. At the P1 inPut CodE, press the (+) button
once and the display will change to
”P2 Print LAyout”. Press the (E) button
once to select the “LAyout”.
7. Press the (-) or (+) button to select the
desired layout. The layout selections are;
right (ri9ht), center (CentEr), and left
(LEFt). Press the (E) button to confirm the
selection and display ”P3 tE5t Print”.
MON TUE WED THU FRI SAT SUN
Blinking
△ △ ▲ △ △ △ △
Ｐ１８ｉｎＰｕｔ
８Ｃ ｏｄ Ｅ８
△ △ ▲ △ △ △ △
Ｐ２８Ｐ ｒｉｎｔ
ＬＡ ｙｏ ｕｔ
△ △ ▲ △ △ △ △
８ＬＡｙｏｕｔ８
８ｒ ｉ９ ｈｔ
MON TUE WED THU FRI SAT SUN
MON TUE WED THU FRI SAT SUN