Operation Manual

3-6
Amano PIX-200 Operation Manual
10. To enter the comments on Line 2, Press (E)
and press (+) when the line number is
blinking. You can program line 3 by
repeating the previous steps.
11. Once you finish programming Customized
Comments, press the (E) button to go back
to the “P1 inPut CodE” Display.
12. If you want to check the printing length,
press the (E) button and select the line by
pressing the (-) or (+) button. You will see
the length in mm to the left of the blinking
line number. (The sample display on the
right shows that line 1 is 35mm)
Note: When the value exceeds the maximum length (35mm), the “Error 05”
will appear on the display when you put the cover on. Please refer to
page 5-2, “Error Codes”.
Note: You can choose the character font when programming the customized
comments. In order to make the imprint clearer, we recommend you to
use Two-Byte Font. Please refer to page 6-3, “Diagram of Font”.
Use the following codes to edit the customized comments:
Code Function
in Insert character
dL Delete character
En End of the sentence
Use the following codes to change the font for customized comments:
Code Function
J Start Two-Byte
Jn Undo Two-Byte
L Start Emphatic Byte
LL Start Double-Width Byte
Ln Undo Emphatic/Double-Width Byte
Un Undo Space Character
Sample of changing the font of “D” “E” “F” from One-Byte to Two-Byte
ABCDEFGHI → 41, 42, 43, 44, 45, 46, 47, 48, 49
ABC
DEFGHI → 41, 42, 43, in, J, 44, 45, 46, in, Jn, 47, 48, 49
See Chapter 6 – Appendix, and the paragraph “Diagram of Character Code”
for more information on codes.
△ △ ▲ △ △ △ △
Ｐ１８ｉｎＰｕｔ
８Ｃ ｏｄ Ｅ８
△ △ ▲ △ △ △ △
Ｐｒｎ８ ＬｉｎＥ
３５８１８８
Blinking