Installation and Operation Guide
MTX-15 installation & Operation Guide Page 3-5
Figure 57: IP Settings Screen
Copy down the Address, Subnet, and Gateway IP settings displayed in
order to configure your Time Guardian time and attendance software.
Press the left function key or esc
key to exit the screen to
maintain the automatic setting.
Note: It is important to exit this screen without saving. If save is
pressed, the terminal will reboot with the displayed address in
manual mode (see below); automatic IP setting will be
disabled.
If you need to set the IP Address manually use the IP Address window.
You may need to obtain the appropriate IP settings from your network
administrator.
Enter the IP Address, Subnet Mask and Gateway settings using the
numeric keypad. The Up
and Down Function keys will allow you
to move between the three fields.
Press the right Function
key to save the settings. This will
automatically reboot the terminal. “Please Wait” and “Rebooting” will
flash along the bottom of the display for a few minutes while the terminal
reboots. The new settings will be in effect after the terminal reboots. The
left Function key or esc
key will exit without saving your setting or
rebooting the terminal.