Installation and Operation Guide
Page 3-4 MTX-15 Installation & Operation Guide
Screen Test
With Screen highlighted press enter on the keyboard to perform
the screen test. This diagnostic tests the display by turning on all the
pixels. Any spots would indicate a defective pixel.
Press the left Function key to return to the main Diagnostic menu.
Network Configuration
This selection will only function on an MTX-15 Terminal with Ethernet
and can be used to configure network communications.
From the main diagnostic screen use the down or up function keys to
highlight Network and press enter on the keyboard to advance
to the IP ADDRESS screen. “Please Wait” will momentarily be displayed
on the bottom.
Figure 56: IP ADDRESS Screen
Automatic IP is the default, which will obtain the settings automatically
when the terminal is connected to the network. If this is acceptable,
press the right Function
key to save the setting and reboot the
terminal. “Please Wait” and “Rebooting” will momentarily flash along the
bottom of the display while the terminal reboots. The left Function key or
esc
key will exit without saving your setting or rebooting the
terminal.
To view the IP address set by the network, from the IP ADDRESS
screen highlight Specify and press enter and the following type
of screen will appear.