Installation and Operation Guide
2-26 MTX-15 Installation & Operation Guide
Time & Attendance Software Communications Module
With the Time & Attendance Software open on the host PC, from the tree
view, click on the Communications module within the Daily Activities
group and the following type of screen should appear for Time Guardian
Plus. Note – the tree view can look a little different depending upon
which modules are activated and/or whether it is Time Guardian Pro (all
modules will be active).
Figure 50: Time & Attendance Software Tree View
Locations are selected by clicking on the desired row (see highlighted
example in Figure 50). You can select multiple locations by holding
down the Ctrl Key and clicking on other locations. Also, you can sort the
displayed Locations list by clicking on the dropdown list in the upper left-
hand corner and selecting on; Name, Description, Term Type, TZ Offset,
Connection, IP, Port, COM Port, Baud Rate, Modem, and Phone. Once
the location is selected use the following commands found at the bottom
of the screen to communicate with the connected MTX-15 terminal(s) at
that location: