Installation and Operation Guide
2-22 MTX-15 Installation & Operation Guide
consult Chapter 3: Network Configuration of this Guide for
additional information about hardware configuration, and
identifying the IP address].
Modem: A modem can be used at the Com Port of the
Host PC to communicate to the terminal(s). If selected,
you must select the Com Port, Baud Rate, Modem Type,
and enter the Phone Number. If your modem is not
available from the list, select a compatible model. This
information should be provided in the modem’s
documentation. The telephone number entered must be
the terminal’s modem. (Include 1 + (Area Code) + 7-digit
phone number, when applicable).
Direct: The MTX-15 terminal(s) are directly connected to
the Host PC via Com Port. If selected, you must select the
Com Port and Baud Rate.
Step 10. Click on the Terminals tab to add, edit, delete, or find
terminals.
Figure 44: Software Setup for Locations with Terminals Tab
Step 11.
To find terminals, click on the Find Terminals button to search
for terminals (see Figure 45).
Figure 45: Software Communicating with Terminals