Installation and Operation Guide

MTX-15 Installation & Operation Guide Page 2-21
Step 2. In the Description field, enter a brief description of the
Location. This field is optional.
Step 3. In the Term Type field; select MTX-15.
Step 4. In the TZ (Time Zone) Offset field, select the time zone
difference (if applicable) between the physical location of your
PC and the MTX-15 terminals.
Step 5. In the Output Path field, enter the path of the output XML file.
If necessary, press the Browse button to navigate to the
location of the XML output file.
Step 6. If necessary, check the “Secondary Output File” box, and In
the Output Path field, enter the path of the secondary output
file. Press the Browse button to navigate to the location of the
secondary output file.
Step 7. For DLS (Daylight Savings Time ) Settings, enter the
following:
 Start Date: The date that the DLS period will begin.
 Start Time: The time of the day of the Start Date that the
DLS period will begin.
 End Date: The date that the DLS period will end.
 End Time: The time of the day of the End Date that the
DLS period will end.
Press the Reset button to Reset the DLS at the Terminal.
Step 8. Click on the Connection tab.
Note: The Port number for Ethernet terminals must be set to;
MTX-15 = 2101, MTX-10 & 20 = 401, FPT-40 = 4370, and
HandPunch’s = 3001.
Step 9. In the Connection field, select the type of connection you are
using to communicate with the MTX-15 terminal(s). The
required information in the Connection Info depends on your
connection.
 Ethernet: The MTX-15 terminals communicate to the Host
PC via Ethernet connection. If selected, you must enter the
IP Address and Port 2101.
[Obtain the correct IP address
from your network administrator, or alternatively, please