Installation and Operation Guide

2-20 MTX-15 Installation & Operation Guide
 Select “MTX-15 Default” on the General tab
from the dropdown
menu for Locations [recommended for easy configuration].
 Click on Connection tab
to select Ethernet for Connection Type and
enter your IP Address. The default MTX-15 Location automatically
defines everything else for Ethernet. Click on
button.
Figure 43: Software Setup for Locations with Connections Tab
A Bell Schedule (optional) and Terminal Validation list should be setup.
You can create a Location to communicate with your MTX-15 terminals.
A Location enables the Time & Attendance software to distinguish and
interact with the desired terminal(s). Only one terminal type can be used
per Location. If you have more than one terminal type, you must have
multiple Locations.
To create a new Location in Time & Attendance software
for the MTX-15 terminal:
Step 1. Click the new + button to create a new Location. You will be
required to enter a unique Name [yellow required field] that will
be used to describe the area or site where a terminal or group
of terminals is located.