Installation and Operation Guide

MTX-15 Installation & Operation Guide Page 2-19
Do you want to configure your Terminals?
Answer Yes to this question if you are using terminals such as a MTX-15
terminal via a serial, Ethernet, or modem connection.
Direct (serial) Connection
If Yes is selected, and a Direct connection
using the included 50 foot
USB/serial cable is desired, you can just use the “MTX-15 Default”
location. You do not have to do anything else. The MTX-15 terminal, if
connected, will automatically be detected upon login.
Note: The default terminal connection is for a USB (serial-direct)
MTX-15 Terminal.
Ethernet (network) Connection
If Yes is selected, and you are installing an Ethernet connection
for the
MTX-15 click on the Location/Terminal
button (see Figure 38) and the Locations screen will appear
(see Figure 42).
Figure 42: Software Setup for Locations