Installation and Operation Guide
MTX-15 Installation & Operation Guide Page 2-17
Use Step 8 if:
Do you have Terminals other than Access Control Terminals?
If Yes, the Time & Attendance software will automatically poll and upload
punches from connected MTX-15 terminals each time the software is
opened.
If No, the connected MTX-15 terminals will have to be polled manually
using the Communications module in the Time & Attendance software.
Do you want to configure Terminal Validation?
If Yes is selected for Terminal Validation, click the Terminal Validation
button and the Terminal Validation screen will appear (see Figure 40).
Terminal validation provides employee filtering from the setup configured
in the General, Department, and Employee tabs in the Time &
Attendance software.
Terminal Validation is used to assign employees and Labor Levels to
specific MTX-15 terminals in the system. When validation is used, only
employees assigned to a particular terminal with the selected Labor
Levels can use that terminal. Labor transfers at the terminal can only
occur within the selected Labor Levels. Terminal Validations are
downloaded to the selected MTX-15 terminals by location from the
Communications module. To do so, see the Time & Attendance Software
User Guide for more detailed information:
Figure 40: Software Setup for Terminal Validation