Installation and Operation Guide

2-4 MTX-15 Installation & Operation Guide
Note: All employee information such as hours, punches, and unlock
schedule is always displayed at the MTX-15 terminal in military
time format (i.e., 5:00PM = 17:00). However, the clock time
displayed is controlled by the settings in the Amano Time &
Attendance software, which can be set to either AM/PM or
military.
Note: When performing View Punches, View Hours, and Unlock
Schedule the same error messages can appear for invalid
punch, etc.
View Employee Punches at MTX-15
The user should be on the main screen as shown below to access the
employee punch information. The terminal will always timeout within 3
seconds of no activity and return to the normal display.
Figure 15: MTX-16 Normal Startup Display
Note: The function buttons shown in Figure 15 will only appear after
successful download with Amano Time & Attendance software.
The coffee break options must be enabled in the Time &
Attendance software for these function buttons to be active.
Step 1. From the normal main display (see Figure 16) press the menu
button on the left to view employee information
(see Figure 17). From this screen, use the Back
button
to exit and return to the main display.
Note: The terminal contains repunch protection. An
error message, “E03 Only one” will appear if you try
to punch more than one within 3 minute period.