Installation and Operation Guide

MTX-15 Installation & Operation Guide Page 1-17
Figure 13: Terminal Status
After display of terminal status, the initial startup display will
appear with January 1, 2000, 12:00 am. Also no function buttons
will be displayed until the terminal is downloaded from the host.
Figure 14: MTX-15 Initial Startup Display
Note: The time and date cannot
be set from the keypad; it must be
downloaded to the terminal using the Time & Attendance
software from the host PC. Pressing any numeric key will
display a flashing “E04 Keypad Lock” on top. All MTX-15
terminal features and functions must be enabled from the host.
Step 3. Once the default time is displayed (see Figure 14), you can
swipe a badge to verify that the badge reader is working. The
badge number will be displayed at the top of the screen.
Step 4. Please insert the Amano Time & Attendance Software CD into
the CD-ROM drive of your PC to install the software. See the
next Chapter for additional details on using your MTX-15
terminal with the Amano Time & Attendance software.