Operation Manual

4-8 CP-5000 User’s Guide
Hours and Minutes (Menu 1, Item 3)
Note: To set the hours and minutes, you must cycle through the
following sequence of displays and save the data entered. The
data entered will not be saved if you exit the Program Mode or
press the Function key before completing all steps.
Note: All time programming is done in 24 hour time format, even if the
time is displayed in 12 hour time format. If you wish to change
the time format for the display, you must do so in the Hours
Display menu item.
1. Remove the cover and enter the pre-determined password. For
password entry information, refer to section Password Entry
Prior to Programming on page 4-6. Upon
correct password entry, the clock will enter the
PROGRAM MODE. The Year menu item will
automatically appear in the display.
2. If applicable, press the Enter key until the
Hours and Minutes menu item appears in
the display with the first pair of digits (hour)
flashing.
3. Press the Change key until the correct hour
(in 24 hour format, 00 thru 23) is flashing in
the display. Holding down the Change key for
more than three seconds will increment the
number in the display by ten.
4. When the correct hour appears, press the
Enter key. The second pair of digits, minutes,
will begin to flash.
5. Press the Change key until the correct
minutes (00 thru 59) appear in the display.
Holding down the Change key for more than
three seconds will increment the number in
the display by ten.
6. When the correct minutes appears in the
display, press the Enter key.