Operation Manual

CP-5000 User’s Guide 2-11
Initialize your CP-5000 as follows:
1. Remove the top cover. Set the Mode Switch to Program/Ink Mode.
2. Insert a small screwdriver into the Reset Hole on the bottom of the
unit and press and hold the Reset button.
3. While holding the Reset button, simultaneously press and hold the
Enter key and the Change key.
4. Release the Reset button; continue to hold
the Enter key and the Change key until five
rapid beeps sound, indicating a successful
reset to all default settings (showing a time of
12:00 AM on January 1, 2007). After a few moments, the clock will
return to its Enter Password mode.
5. Enter the default password (0000) and reprogram the unit as
desired. Set the Mode Switch to Normal and reinstall the top cover.
When the AC power is properly connected, the LED will cease to flash
and the LCD display will show normal time indication in the (12 hour)
format:
Note: If using the Full Power Reserve Battery, to insure premium
performance, it is recommended that the battery be fully charged
prior to use (approximately 24 hours).
Note: If using the Full Power Reserve Battery, to avoid damaging the
battery or draining it to an unrecoverable level, keep the machine
plugged into an AC power source during normal operation. The
Full Power Reserve Battery is intended for limited power outage
usage, and not as a power source during normal operations.