Operation Manual

2-8 CP-5000 User’s Guide
Optional Accessory Battery Pack (ATR-20095x)
Installing the Full Power Reserve Battery (available as a kit: P/N ATR-
20095x) will allow the CP-5000 to maintain normal operations for 12
hours or 300 punches in the event of an AC power failure.
Installation
Note: This procedure must be performed with the power cord
disconnected from the power source.
To install the Full Power Reserve Battery perform the following steps:
1. Remove the top cover.
2. Remove the front cover.
3. Remove the back plate.
4. Remove the backing paper from the Velcro.
5. Slide the battery pack into the compartment and press firmly into
place to allow the adhesive on the Velcro fastener to hold.
6. Feed the battery cable through the cable feed slot at the top of the
battery compartment and over the top of the PC board.
7. Connect the battery cable to FPR on the PC Board.