Handing Manual

6 4700/4800 Series Time Stamp Operation Manual
Adjustment of Printing Position
(Refer to Fig. 8, 9 & 10)
• The printing position can be adjusted by moving the knob [11]
(see Figures 8 & 9) between 37 mm – 83 mm (1.5” – 3.25”) from
the top of the paper. When the upper die plate hammer is taken
out, the printing position can be within 16 mm – 83 mm (.66” –
3.25”) from the top of the paper.
• For easy setting of the printing position, refer to the mark on the
side plate.
• Incase the printing position is to be fixed, tighten the screw [12]
(see Figure 9), and remove the knob [11].
• Incase the upper die plate is installed, please make sure the
screw [13] is tightened. Remove the screw [13] if the upper die
plate is not equipped.
Ribbon
Fixer

Ribbon
Spool
8
Ribbon
Guide Shaft
9
Figure 7.
Ribbon
Spool
7