Installation manual

Chapter 10: Programming the Samsung DCS 2.2/Compact 87
d. Press UP to go to the next option.
e. Go on to the next numbered step.
2. The display shows:
Follow the directions given in step 1, depending on whether the setting is as shown or
not as shown.
3. The display shows:
Follow the directions given in step 1, depending on whether the setting is as shown or
not as shown.
4. The display shows:
Follow the directions given in step 1, depending on whether the setting is as shown or
not as shown.
5. The display shows:
Follow the directions given in step 1, depending on whether the setting is as shown or
not as shown.
6. The display shows:
If the setting is as shown above:
a. Press UP to go to the next option.
b. Go on to step 7.
If the setting is not as shown above:
a. Press the RIGHT softkey to move the cursor to the bottom line of the display.
b. Press C.
c. Press UP to go to the next option.
d. Go on to step 7.
7. The display shows:
T
RK FOR DN1
YES
E
XT FOR DN2
NO
T
RK FOR DN2
NO
S
EPARATOR
NO
D
ISCONECT SIGNAL
C
C
ALL TYPE ID
DIRECT CALL:*