Installation manual

86 Telephone Switching Systems for Amanda@SOHO

4. Do one of the following:

• Press TRSF to store and exit.

• Press SPK to store and advance to the next MMC.

Programming MMC: 726

You use MMC: 726 to set a series of VM/AA Options. There are eight main options for

programming and several sub-options. Many of them are YES/NO. Others require a few

numbers or letters of the alphabet. While you use the default settings in almost all cases, it

is best to check that the settings are the ones they are supposed to be.

When programming MMC: 726, you use the following program keys:

To set VM/AA options:

1. Press TRSF then dial 726.

The display shows the EXT for DN1 option and its default setting YES:

2. If the setting is as shown above:

a. Press UP to go to the next option.

b. Go on to the next numbered step.

If the setting is not as shown above:

a. Press the RIGHT softkey to move the cursor to the bottom line of the display.

b. Press UP or DOWN to change NO to YES.

c. Press the RIGHT softkey to move the cursor to the top line of the display.

Purpose Key

Scroll through a set of options UP and DOWN arrows

Enter selection Keypad

Move cursor right and left RIGHT and LEFT Softkeys

Move cursor from top to bottom line on

display (or vice versa)

RIGHT and LEFT Softkeys

Store data and advance to next MMC SPK

Clear entry HOLD

Store and exit TRSF

Inputs the letter A A

Inputs the letter B B

Inputs the letter C C

XT FOR DN1

YES