Installation manual

Chapter 9: Programming Panasonic DBS 824 81
To Use a Voice Mail Transfer Key
Programming a transfer key allows the users at that extension to forward a caller directly
to voice mail without inband signalling. The extension call will go to the Company
Greeting mailbox (usually 990).
To program a transfer key:
1. Press the ON/OFF key.
2. Press the PROG key.
3. Press an FF key that is non-CO and has a light.
4. Press the CONF key.
5. Press the AUTO key.
6. Press the AUTO key again.
7. Dial the voice mail hunt pilot (probably 50 or 500) that you entered in “Programming
the Hunt Group” on page 75.
8. Press the HOLD key.
9. Press the ON/OFF key.
10. Repeat steps 1 through 9 on each user’s telephone.
Notification and Integration Files
For each telephone switching system, Amanda@SOHO stores files with notification, dial
code, and integration information. When you select a telephone switching system,
Amanda knows which files to use for your switch. The files contain:
• The tokens that turn the message waiting light on are in c:\amanda\pbx.db\192.on.
This file contains the tokens “*4-%E”.
• The tokens that turn the message waiting light off are in
c:\amanda\pbx.db\192.off.
This file contains the tokens “*5-%E”.
• The dial codes and integration strings used by the switch are in c:\aman-
da\pbx.db\192.pbx.