Installation manual

80 Telephone Switching Systems for Amanda@SOHO
5. Enter the extension number.
6. Enter the extension number again.
7. Press the HOLD key.
8. Press the ON/OFF key.
9. Repeat steps 1 through 8 on each user’s telephone.
To Use a Voice Mail Message Key
You should program a voice mail message key from every system (not single-line)
telephone. The message key lights up when a message is waiting and when pressed will
send “8xxx” (where xxx is the telephone’s extension number) to voice mail for a direct
login.
To program the message key:
1. Press the ON/OFF key.
2. Press the PROG key.
3. Press an FF key that is non-CO and has a light.
4. Press the CONF key.
5. Press the AUTO key.
6. Dial the voice mail hunt pilot (probably 50 or 500) that you entered in “Programming
the Hunt Group” on page 75.
7. Press the AUTO key.
8. Dial 909 or 99, depending on the software version of your telephone switching sys-
tem.
9. Press the HOLD key.
10. Press the PROG key.
11. Press the AUTO key.
12. Dial 909 or 99 (must match step 8).
13. Dial 8.
14. Dial the current telephone’s extension number.
15. Press the HOLD key.
16. Press the ON/OFF key.
17. Repeat steps 1 through 16 on each user’s telephone.