Installation manual

Chapter 9: Programming Panasonic DBS 824 75
Programming the Hunt Group
The hunt group is terminal. In a terminal hunt group, the hunt begins with the pilot
number, and moves sequentially through the extensions in the hunt group. If all the
extensions are busy, the call camps onto the hunt group and waits for an extension to
become idle.
To program the hunt group:
1. Start programming as explained in “Getting Started” on page 73.
2. Press the FF4 key.
3. Dial 3#.
4. Enter the number for this hunt group (1-4).
5. Dial #1#.
6. Enter the hunt group pilot number (any number in these ranges: 11-69 for CPC-S or
101-699 CPC-M).
We suggest using 50 or 500. Write down the number you used here. You will need to
use it again in the sections “To Use a Voice Mail Message Key” on page 80 and “To
Use a Voice Mail Transfer Key” on page 81.
7. Dial #.
8. Press the FF4 key.
9. Enter the number for this hunt group (1-4).
10. Dial #2#.
11. Dial 0# for terminal hunting.
12. Press the FF4 key.
13. Dial 3#.
14. Enter the number for this hunt group (1-4).
15. Dial #5#.
16. Enter the extension number for the first Amanda port.
17. Dial #.
18. Press the HOLD key.
19. Repeat steps 16 through 18 for each Amanda port.