Installation manual

Chapter 9:
Programming Panasonic DBS 824
Getting Started
Connect the Amphenol cable from the KSU to the punch down block. Cross connect the
system wire runs to the station wire runs or to modular RJ-11 connectors.
Use a single-line telephone adaptor (SLTA) to support up to four analog telephones.
Requires one digital port per analog port.
You can program the Panasonic 834 from up to four telephones so long as the attendant
display telephone. A telephone that is connected to extension port1 with an extension
number of 100 is automatically an attendant telephone.By default, extension port 2
(extension number 101) is the second attendant telephone, although this extension can be
reprogrammed.
The information in this chapter is for Panasonic DBS 824 software versions CPC-S and
CPC-M 1.0 and higher.
To start programming:
1. Press the ON/OFF key.
2. Press the PROG key.
3. Press ##.
4. Then you press an FF key.
The keys with the lights on them are FF1 through FF8.
Typically they are labeled Line 1 through Line 8.
5. After the FF key, you dial a series of digits, depending on the program and your
needs.
6. Press the HOLD key to store your entry and move forward (to the next port number or
program number).
To stop programming:
• Press the ON/OFF key.