Installation manual

68 Telephone Switching Systems for Amanda@SOHO
NEXT
(Press 6 if not already
there.)
FWD VM RBT:6
SKP+ CLR NEXT
NEXT
(Press 7 if not already
there.)
FWD VM BT:7
SKP+ CLR NEXT
NEXT
(Press 8 if not already
there.)
FWD EXT RBT:6
SKP+ CLR NEXT
Mailbox ID Code: Make sure that all the jacks/ex-
tension have the value “Not Stored”.
609
Mailbox ID Code
SKP+ CLR NEXT
NEXT
Jack NO?->
SKP+ CLR NEXT
NEXT
#01-1:Not Stored
-> SEL NEXT
If not “Not Stored” i.e.
blank, press SHIFT to
toggle to
#01-1:Not Stored
-> CLR NEXT
If not “Not Stored” i.e.
blank, press CLR
#01-1:
-> CLR NEXT
Repeat last three steps
for all jacks/exten-
sions.
Call Forwarding: Provide the code needed to leave
and get messages.
114
VM Command Set
SKP+ CLR NEXT
NEXT
#6H
(to get the H, press the
FLASH button)
LV-MSG:#6H
NEXT
*H#
GETMSG:*H#
-> SEL NEXT
Operator/Manager: Enter the jack number that the
operator is assigned to as OPE-1. If you have a back-
up operator, enter the jack number for that person as
OPE-2.
You can also use this program to set a jack number
for the manager. This provides an additional jack
from which programming can be done.
006 Operator/Manager
SKP+ CLR NEXT
NEXT OPE-1:Jack01
-> SEL NEXT
Program and Its Purpose What You Enter What You See on Display