Installation manual

66 Telephone Switching Systems for Amanda@SOHO
Getting Ready
Programming the Panasonic KXTD 1232 can be performed only from Jack 1, and only
one telephone can be in programming mode at one time. While you are programming,
your extension is treated as a busy extension.
Before programming, confirm that:
• Your telephone is on-hook.
• No calls are on hold at your telephone.
To start programming:
1. Press PROGRAM * #1234.
1234 is the default system password. Your telephone switching system may have
another password.
2. When SYS-PGM NO? -> appears on the display, you dial the number of the program
you want to use.
To finish one program and go on to another:
1. Press STORE to store your changes.
The STORE indicator light becomes red and you hear a beep if your changes were
successfully stored.
If you hear the alarm (three beeps), check that your entry is valid.
2. Press END.
3. Dial the number for the next program.
To exit programming mode do one of the following:
• Lift the handset.
• Press END. When the initial message: SYS-PGM NO? -> appears on the display,
press PROGRAM.
Programming a Panasonic
The following table explains what programs to use as you set up a Panasonic for use with
Amanda.
Program and Its Purpose What You Enter What You See on Display
Start programming PROGRAM *#1234 SYS-PGM NO? ->
CLR NEXT
Call Hunting: Program the extension group that is
assigned to Amanda for voice mail
106 Call Hunting
SKP+ CLR NEXT
NEXT EXT GRP NO?->
SKP+ CLR NEXT
NEXT (or type group
number)
Groupx: Disable
-> SEL+ NEXT