Installation manual

Chapter 7: Programming the NEC Electra II 63
• The tokens that turn the message waiting light off are in
c:\amanda\pbx.db\171.off.
This file contains the tokens “7#%U”.
• The dial codes and integration strings used by the switch are in
c:\amanda\pbx.db\171.pbx.
This file contains the following lines:
NEC Electra II (release 3.00+)
####################################################
# NEC Electra Level II #
####################################################
dl_dtwait F-- # Dial code to put a caller on transfer hold :
dl_ndtret - # Dial code to use when there is no transfer dialtone:
dl_rnaret F- # Dial code to return to caller after Ring No Answer :
dl_bsyret F- # Dial code to return to caller when there is a Busy :
dl_hupret F- # Dial code to use after a call screening reject :
dl_connect H # Dial code to connect the caller to the extension :
tmo_dtwait 4 # Number of seconds to wait for dialtone detection :
flashtm 60 # Number of 1/100 seconds to use for Flash time :
dt_answer # Which DTMF tone to listen to for answer detection :
dt_hangup # Which DTMF tone to listen to for hangup detection :
dl_prefix # What to dial BEFORE dialing the User ID extension :
dl_suffix H # What to dial AFTER dialing the User ID extension :
dl_init # What to dial when the system first starts up :
dl_stop # What to dial when the system performs a shutdown :
dl_pickup # What to dial when a port goes off-hook :
dl_conference# What to dial to create/record a conference call :
integration 10 ‘rr’
integration 10 ‘rrr’
integration 10 ‘rrrr’