Installation manual

Chapter 7: Programming the NEC Electra II 61
Programming sample:
Tel Port No. Data No. Title Setting Data.
25/ _______14___ICMFWD__ 303
9. Press the TRF key.
10. Repeat steps D through G for the rest of the voice mail ports in the hunt group.? for
the rest of the extension in the hunt group?
Programming a Quick Transfer
To set the quick transfer to the extension for the first port:
1. Press the LK1 key.
2. Press 8.
This puts you in memory block 1-8.
3. Enter the extension (for example, 300) for the first port.
4. Press the TRF key.
Programming the Interior Ring Pattern
To set the Interior Ring Pattern:
1. Press the LK1 key.
2. Press 2.
This puts you in memory block 1-2.
The setting should default to B, which is a ring that is 1 second on and 2 seconds off.
For a longer ring, change the setting to A.
While C and D are possible settings, their rings are too short to be usable in most
environments.
3. Press LK4 for B or LK3 for A.
Programming Message Waiting Indications (MWI)
To program MWI:
1. Press the LK1 key.
2. Press 1.
This puts you in memory block 1-1.
3. Go to the Dial code field.