Installation manual

Chapter 7: Programming the NEC Electra II 59
Programming Voice Mail Access
The hunt group should be circular.
To program voice mail access:
1. Press the FNC key.
2. Press #0*8974.
3. To learn what physical port number is the first voice mail port:
a. Press the LK7 key.
b. Press 1.
This puts you in memory block 7-1, the card interface slot assignment.
c. Press the TRF key until the unit name SLI8G-21 appears on the display.
The first port on this card is on the lower right of the display. It is a two-digit
number. You must know which Single Line Ports you are using for voice mail
before you can proceed. (For example, the port number might be 25.)
Programming sample:
Page No. Upper Slot No. Unit Name Port No.
1_________16:_______________=31
1>________08:____SLI8G-21___=25
4. To give that physical port an extension number, for example, 300:
a. Press the LK4 key.
b. Press 10.
This puts you in memory block 4-10, for station number assignment.
c. Go to the Tel Port No. and type the two-digit port number for the first port
(from Step 3C). (For example, you might type 25.)
d. Type the extension number (for example, 300) to be assigned to that port.
Programming sample:
Port No. Data No. Title Setting Data.
25________10____STA_____=300
e. Press the TRF key.
The next physical port (for example 26) appears on the display.
f. Type the next extension (for example, 301).
g. Repeat Steps E and F for the rest of the ports.
N
OTE
: You must know what extensions/station have been assigned to what
ports.