Installation manual

52 Telephone Switching Systems for Amanda@SOHO
7. To record messages, press 667.
8. Press the TRF key to write the setting to the database and move on to access code
VM05.
9. To forward all calls, press 667.
10. Press the TRF key to write the setting to the database and move on to access code
VM06.
11. To forward busy, press 666.
12. Press the TRF key to write the setting to the database and move on to access code
VM07.
13. To forward no answer, press 667.
14. Press the TRF key to write the setting to the database and move on to access code
VM08.
15. Press the TRF key again to move on to access code VM09.
16. To detect the DTMF disconnect signal, make the setting 999#.
To do that, you press 999+ LNR/SPD + #.
17. Press the TRF key again to move on to access code VM10.
18. To program the message lights on, press 641.
19. Press the TRF key to write the setting to the database and move on to access code
VM11.
20. To program the message lights off, make the setting 64*.
To do that, you press 64+ LNR/SPD + *.
21. Press the TRF key to write the setting to the database.
22. Press the SPKR key to stop programming.
Programming Night and Day Modes
By default, telephones connected to port numbers 01 and 02 ring on all incoming CO/PBX
calls. Telephones connected to ports number 03+ do not ring on any incoming CO/PBX
calls.
To change this programming for day or night mode:
1. Press the FNC key.
2. Press the HOLD key.
3. Press #0*.