Installation manual

Chapter 6: Programming the NEC Electra, Level I 51
To program the hunt group:
1. Press the FNC key.
2. Press the HOLD key.
3. Press #0*
4. Assign physical ports to the logical voice mail extensions.
a. Press the LK4 key.
b. Press 06.
This places you in memory block 4-06.
The first port number appears on the display.
c. Press 50.
d. Press the TRF key to write the setting to the database.
e. Repeat steps C and D for each port.
After typing 50 for the last port, you enter memory block 4-07.
5. In memory block 4-07, you assign voice mail functions to ports.
a. Press 1 for Yes.
b. Press the TRF key to write the setting to the database.
c. Repeat steps C and D for each port.
6. Press the SPKR key to stop programming.
Programming System Mode
System mode has the following features:
• Record Message
• Forward All Calls
•Forward Busy
• Forward No Answer
• DTMF Disconnect Signal
• Message Waiting Indication
To program these features:
1. Press the FNC key.
2. Press the HOLD key.
3. Press #0*.
4. Press the LK1 key.
5. Press 67.
This places you in memory block 1-67.
The access code is VM01 and represents port one.
6. Press the TRF key until the access code becomes VM04.