Installation manual

40 Telephone Switching Systems for Amanda@SOHO
• The dial codes and integration strings used by the switch are
c:\amanda\pbx.db\121.pbx for two-digit extensions and
c:\amanda\pbx.db\122.pbx for three-digit extensions.
121.pbx contains the following lines:
####################################################
# Comdial DSU/Unison, 2-digit dial plan #
####################################################
dl_dtwait F, # Dial code to put a caller on transfer hold :
dl_ndtret F- # Dial code to use when there is no transfer dialtone:
dl_rnaret F- # Dial code to return to caller after Ring No Answer :
dl_bsyret F- # Dial code to return to caller when there is a Busy :
dl_hupret F- # Dial code to use after a call screening reject :
dl_connect H # Dial code to connect the caller to the extension :
tmo_dtwait 0 # Number of seconds to wait for dialtone detection :
flashtm 55 # Number of 1/100 seconds to use for Flash time :
dt_answer # Which DTMF tone to listen to for answer detection :
dt_hangup A # Which DTMF tone to listen to for hangup detection :
dl_prefix , # What to dial BEFORE dialing the User ID extension :
dl_suffix H # What to dial AFTER dialing the User ID extension :
dl_init # What to dial when the system first starts up :
dl_stop # What to dial when the system performs a shutdown :
dl_pickup # What to dial when a port goes off-hook :
dl_conference # What to dial to create/record a conference call :
integration 10 ‘rr2’
integration 10 ‘rr3’
integration 10 ‘ee0’
integration 10 ‘9*ee’
integration 10 ‘rr’
122.pbx contains the following lines:
####################################################
# Comdial DSU/Unison, 3-digit dial plan #
####################################################
dl_dtwait F, # Dial code to put a caller on transfer hold :
dl_ndtret F- # Dial code to use when there is no transfer dialtone:
dl_rnaret F- # Dial code to return to caller after Ring No Answer :
dl_bsyret F- # Dial code to return to caller when there is a Busy :
dl_hupret F- # Dial code to use after a call screening reject :
dl_connect H # Dial code to connect the caller to the extension :
tmo_dtwait 0 # Number of seconds to wait for dialtone detection :
flashtm 55 # Number of 1/100 seconds to use for Flash time :
dt_answer # Which DTMF tone to listen to for answer detection :
dt_hangup A # Which DTMF tone to listen to for hangup detection :
dl_prefix , # What to dial BEFORE dialing the User ID extension :
dl_suffix H # What to dial AFTER dialing the User ID extension :
dl_init # What to dial when the system first starts up :
dl_stop # What to dial when the system performs a shutdown :
dl_pickup # What to dial when a port goes off-hook :
dl_conference # What to dial to create/record a conference call :
integration 10 ‘rrr2’