Installation manual

Chapter 4: Programming the Comdial Unisyn 39
5. Dial the number of the first voice mail port.
6. Dial *** to finish but stay in configuration mode.
To program the line to delay ring to the voice mail system:
1. If you are not already in configuration mode, dial ITCM *#746*.
2. Dial 54 “STA/LINE CONFIG”.
3. Dial 2 “DELAY RING”.
4. Press the line button (B1 through B6) for the private line. (In the example, you would
have pressed B3 for line 3.)
5. Press #.
6. Dial the station number plus 2 (in this example, you would dial 142).
7. Dial *** to finish but stay in configuration mode.
Programming a Direct Login Button
A Direct Login button allows users to reach voice mail by pressing that button. Each
station must be programmed individually.
1. Dial ITCM **1.
2. Press the button on the telephone set to be used for direct login.
3. Press ITCM again.
4. Dial the number for the voice mail system.
5. Press HOLD.
6. Dial 9.
7. Press SPKR.
Notification and Integration Files
For each telephone switching system, Amanda@SOHO stores files with notification, dial
code, and integration information. When you select a telephone switching system,
Amanda knows which files to use for your switch. The files contain:
• The tokens that turn the message waiting light on are in c:\amanda\pbx.db\121.on
for two-digit extensions and c:\amanda\pbx.db\122.on for three-digit extensions.
This file contains the tokens “,*3,%E”.
• The tokens that turn the message waiting light off are in c:\amanda\pbx.db\121.off
for two-digit extensions and c:\amanda\pbx.db\122.off for three-digit extensions.
This file contains the tokens “,#3,%E”.