Installation manual

Chapter 4: Programming the Comdial Unisyn 37
To program message waiting light for voice mail ports:
1. If you are not already in configuration mode, dial ITCM *#746*.
2. Dial 53 “STATION FEATURES”.
3. Dial 06 for “MSG. WAIT ORIG.”.
4. Select the station ports to be assigned this feature by dialing 10 through 25 or A1
through A16. (The station is assigned if the LED is on.)
5. Dial * to assign stations to another prime line or ** to finish but stay in configuration
mode.
Setting Up Ringing Line Preference
When you assign this feature to a station, that station automatically answers a ringing line
when its user goes off-hook. The ringing line shows as an orange LED only when you
have canceled Ringing Line Preference. The IST ports must have ringing line preference
assigned.
To program ringing line preference:
1. If you are not already in configuration mode, dial ITCM *#746*.
2. Dial 53 “STATION FEATURES”.
3. Dial 09 for “RING LINE PREF.”
4. Select the station ports to be assigned this feature by dialing 10 through 25 or A1
through A16. (The station is assigned if the LED is on.)
5. Dial * to assign stations to another prime line or ** to finish but stay in configuration
mode.
Other Considerations
This section covers some other features that may be of interest to you: Timed Hold Recall
and Unanswered Call Transfer Recall. It also covers how to program private lines.
Using Timed Hold Recall
When you place a caller on hold, the call will ring at your station after the pre-
programmed time limit. If you find that your calls are ringing back too soon and ending up
in your voice mailbox because you are on another call, you might consider setting the hold
recall time to 3 or 4 minutes.
To use timed hold recall:
1. If you are not already in configuration mode, dial ITCM *#746*.
2. Dial 14 “HOLD RECALL XXXX”.