Installation manual

Chapter 4: Programming the Comdial Unisyn 35
The Comdial Unisyn manual skips a step needed when you set up call forwarding, so use
the following procedure.
To program call forwarding:
1. If you are not already in configuration mode, dial ITCM *#746*.
2. Dial 53 “STATION FEATURES”.
3. Dial 21 “CALL FWD RNA”.
4. Dial 1 through 9 for the number of rings before forwarding.
5. Select the station ports by pressing the A1 to A16 buttons.
6. Press ** to return to configuration mode.
7. Dial 16 (How Internal Stations Answer Calls).
8. Dial 2 (Tone Announce First).
9. Dial ***.
Setting Up the Intercom Hunt Group
To program the intercom hunt group:
1. If you are not already in configuration mode, dial ITCM *#746*.
2. Dial 53 “STATION FEATURES”.
3. Dial 18 “ITCM HUNT LINK”.
4. Select a station that will hunt for the voice mail system using the A1 through A16 but-
tons.
N
OTE
: Select only one station at a time. The DSS light will be steady.
5. Select the first station port in the voice mail system using the A1 through A16 but-
tons. The light should blink.
6. Dial * when all the line ports have been selected.
7. Repeat steps 4 through 6 until all the stations that will hunt for the voice mail system
have been linked.
8. When finished, dial ***.
Setting Up Line Groups
You need to group outside lines of the same type together for dial-up outgoing access.
This is required to call an outside telephone number or a pager. Access codes for the line
groups are as follows: