Installation manual

Chapter 4: Programming the Comdial Unisyn 31
Configuring the Ports
You can program a station port to accept one of several different types of station
equipment, such as:
• Multiline telephone (Multiline without LCD)
• LCD (LCD speakerphone)
• Execumail
The system defaults to LCD, so all the station ports on a new system are LCD.
When you program a station port as a voice mail port, the telephone system automatically
makes the following changes:
• No dial tone on port
• RR2 - Integration for a station busy/no answer forwarded to voice mail
• System sends DTMF 9 to voice mail when called by an internal caller
• Message waiting lights are handled automatically (if you have the TXMSG Mes-
sage Waiting Board)
To enable stations as voice mail ports:
1. If you are not already in configuration mode, dial ITCM *#746*.
2. Dial 51 “PORT TYPE”.
3. Select 08 to define the voice mail ports.
The A1 to A16 buttons light up to indicate any ports already defined for voice mail.
4. Select all station ports that will be voice mail ports. Choose from stations 10 to 25 by
dialing their numbers or, better yet, press A1 to A16. See the table below.
5. Press * to check the LCD port.
6. Press 07.
The A1 to A16 buttons light up to indicate any ports already defined as LCD.
Make sure that NO voice mail ports are selected. Also make sure that the rest of the
ports are selected.
7. Press ** to finish but stay in configuration mode.
Port
DSS Button to
Press
10 A1
11 A2
12 A3
13 A4
14 A5
15 A6