Installation manual

30 Telephone Switching Systems for Amanda@SOHO
Programming the Unisyn for Voice Mail
Programming the Unisyn is simple and straight forward. To program the voice processing
integration, you need to be aware of the following:
1. Programming is done from either station 10 or 12 only.
2. To enter configuration mode, dial ITCM *#746*.
3. Define the voice mail station ports as Execumail before doing any other programming
on the voice mail ports. If you fail to do this, all programming to the ports is lost when
you eventually define them as Execumail ports.
Do not change the station port types for the telephones in the system. Define only the
ports you plan to connect to Amanda as voice mail ports.
4. Comdial has defined the entire process of integrating the Unisyn with a voice mail
system in part 3.9 of the Unisyn manual. The essentials from that section have been
reproduced in this chapter.
5. After the voice mail integration, you need to set up each station to call forward (when
there is no answer) to the voice mail system as explained in this chapter. (Follow the
directions in this chapter because there is a slight error in the Unisyn manual.)
6. To end programming, press SPKR.
Use the following figure to locate buttons.
*
7
PRS
4
GHI
1
0
OPER
8
TUV
5
JKL
2
ABC
#
9
WXY
6
MNO
3
DEF
B4
B1
B5
B2
B6
B3
A1
A2
A3
A4
A5
A6
A7
A8
A9
A10
A11
A12
A13
A14
A15
A16
SPKR
HOLD
CONF
TAP
MUTE
ITCM
COMDIAL
Programmable
buttons
(A-Field)
Mute
button
Volume
control
Intercom
button
Tap
button
Hold
button
Message
waiting
light
Speaker
button
Transfer/
Conference
button
Speaker
Programmable
buttons
(B-Field)