Installation manual

Chapter 3:
Programming the
AT&T Partner II
Getting Started
To connect Amanda to the switching system:
1. Run direct wiring from RJ-11 jack (one-pair) on Partner 206 module to RJ-11 jack
(two-pair) on the voice board.
2. Run wiring from 66 block to RJ-11 jack (two-pair) to the Amanda Rhetorex voice
board.
OR
• Use four RJ-11 mounting cords, one cord for each voice mail port. Plug one into
each extension port on the 206 Module.
To start programming the AT&T Partner:
•Press
.
To exit programming the AT&T Partner:
•Press
.
Programming is done only from extension 10 or 11.
Using Amanda as a Primary Automated Attendant
If you are using Amanda as a primary automated attendant, you need to read the following
sections. Many of these sections also apply to using Amanda as a backup attendant or a
voice messaging center; sometimes the settings are identical. Sometimes they are
different. Be sure to use the settings for the primary automated attendant.
Section to read: To program:
Programming Hunt Group 7 #505 Hunt Group Extensions
Assigning Extensions to Ring-
No-Answer Service
#310 VMS Cover
Setting the Number of Rings for
No Answer
#117 VMS Cover Rings
Determining When Voice Mail
Answers Calls
#506 VMS Hunt Delay