Installation manual

Chapter 14: Programming the WIN 36D 151
4. Dial 1.
The display reads:
1:CFWD DIRECT
5. Press the HOLD key.
The display reads:
ID=0?
6. Dial #1 then press the fifth soft key (across the top of the telephone) to type an E.
The display reads:
#1E
7. Press the HOLD key.
The display reads:
ID=#1E?
8. Press the CO8 key to save your data and exit program 109.
The display reads:
QUIT
9. Press the HOLD key.
The display reads:
PROGRAM NO. ?_
10. Repeat steps 2 through 9 using 2 as the Table No. and #2E as the inband signaling
digits.
11. Repeat steps 2 through 9 using 3 as the Table No. and #1E as the inband signaling
digits.
12. Repeat steps 2 through 8 using 4 as the Table No. and #4E as the inband signaling
digits.
13. Press the HF key.
The current date and time appear on the display.
Using Amanda as a Primary Automated Attendant
Program 507 defines the type of trunk for each CO line. To use Amanda as an automated
attendant, each CO line must be set to 2: DIL. Then, using programs 505 and 506, you
make the first extension in your hunt group the DIL station for day and night.
To use Amanda as an automated attendant:
1. Press FEAT + 01# + FEAT + FEAT (to start programming).
The display reads:
PROGRAM NO. ?_