Installation manual

150 Telephone Switching Systems for Amanda@SOHO
3. Press the HOLD key.
The display reads:
S10:cf TO S00?
4. Dial the extension (18, for example) to which the call should be forwarded when
extension 10 is busy.
The display reads:
S10:cf TO S18
5. Press the HOLD key to move to S11.
6. Repeat steps 4 and 5 for each extension that should be forwarded.
N
OTE
: Leave all voice mail ports set to S00 (for no forwarding).
For example,
S18:CF TO S00?
7. Press the CO8 key to save your data and exit program 306.
The display reads:
QUIT
8. Press the HF key to stop programming.
The current date and time appear on the display.
Programming Voice Mail Extended Inband
Signaling
Normally, when a call forwards from a station on the WIN 36D to a single-line port that
has been designated as a voice mail port (using program 309), certain digits (in addition to
the extension number from which the call is being forwarded) indicate that this call should
be sent directly to a mailbox to take a message. These extra digits are programmed using
the following program (109).
To extend inband signaling:
1. Press FEAT + 01# + FEAT + FEAT (to start programming).
The display reads:
PROGRAM NO. ?_
2. Dial 109.
The display reads:
109:V/M DATA SET
3. Press the HOLD key.
The display reads:
TABLE NO ?