Installation manual

Chapter 14:
Programming the WIN 36D
Getting Started
This chapter covers the WIN 36D and 36DX.
To connect Amanda@SOHO to a WIN 36D, you need:
• One DTMF card (PW-13084B 24D DTMF MLS)
• One of the following:
• One ULC-D card and two 2STL cards (for four analog ports)
• One 8STL card (for eight analog ports)
Run RJ-45 four-pair wire from the 8STL to cross connect. Connect two-pair wire (inside/
outside pair) to each RJ-11 plug.
All programming of the telephone switching system must be done from station 10.
To start programming:
1. Press the FEAT key.
2. Press 01#.
3. Press the FEAT key.
4. Press the FEAT key again.
The display reads:
PROGRAM NO. ?_
To stop programming:
1. Press the CO8 key.
The display reads:
QUIT
2. Press the HF key.
The current date and time appear on the display.