Installation manual

122 Telephone Switching Systems for Amanda@SOHO
4. Press Hold.
5. Press Spkr.
6. Do one of the following:
• On a DK-8, dial 008*009.
This represents ports 8 and 9, and, therefore, extensions 18 and 19.
• On a DK-16 or DK-16e, dial 008*011.
This represents ports 8 through 11, and, therefore, extensions 18 through 21.
7. Make sure that the following LEDs are ON:
5, 9, 15, 16, 17, 18, 19, 20
All others must be OFF.
8. Press Hold.
Notification and Integration Files
For each telephone switching system, Amanda@SOHO stores files with notification, dial
code, and integration information. When you select a telephone switching system,
Amanda knows which files to use for your switch. The files contain:
• The tokens that turn the message waiting light on are in c:\amanda\pbx.db\250.on,
c:\amanda\pbx.db\251.on, and c:\amanda\pbx.db\252.on.
This file contains the tokens “63%E” for the Toshiba DK-8 and Toshiba DK-16.
It contains the tokens “#63%E” for the Toshiba DK-16e.
• The tokens that turn the message waiting light off are in
c:\amanda\pbx.db\250.off, c:\amanda\pbx.db\251.off, and
c:\amanda\pbx.db\252.off.
This file contains the tokens “64%E” for the Toshiba DK-8 and Toshiba DK-16.
It contains the tokens “#64%E” for the Toshiba DK-16e.
• The dial codes and integration strings used by the switch are in
c:\amanda\pbx.db\250.pbx, c:\amanda\pbx.db\251.pbx, and
c:\amanda\pbx.db\252.pbx.
This file contains the following lines for the Toshiba DK-8:
Toshiba DK-8
####################################################
# Toshiba DK-8 #
####################################################
dl_dtwait F- # Dial code to put a caller on transfer hold :
dl_ndtret F- # Dial code to use when there is no transfer dialtone:
dl_rnaret F- # Dial code to return to caller after Ring No Answer :
dl_bsyret F- # Dial code to return to caller when there is a Busy :
dl_hupret F- # Dial code to use after a call screening reject :
dl_connect H # Dial code to connect the caller to the extension :
tmo_dtwait 4 # Number of seconds to wait for dialtone detection :
flashtm 55 # Number of 1/100 seconds to use for Flash time :
dt_answer # Which DTMF tone to listen to for answer detection :
dt_hangup D # Which DTMF tone to listen to for hangup detection :